- #SETTING UP FARSKY TELEMITRY MANUAL#
- #SETTING UP FARSKY TELEMITRY SERIES#
Press ENTER and turn the knob till the desired mode is selected Turn the knob clockwise till the mode field is selected.Press MENU to get to the MODELSEL screen.
#SETTING UP FARSKY TELEMITRY MANUAL#
The mode to use is specified in the X7 manual downloaded from here
#SETTING UP FARSKY TELEMITRY SERIES#
Identify the receiver (Rx) series and Tx mode. Press EXIT twice to reach the Main view. Turn the knob any direction till 2 appears. Turn the know clockwise till the number below Mode is selected. Long press MENU till the RADIO SETUP screen is visible. Turn counterclockwise, left, to move selection backwards or up Turn clockwise to move selection (cursor) forward or down Many more possibilities which will be covered in a separate post Press to go back from one view to previous view Long Press to change from main view to Tx configuration screens Press to change from main view to model configuration screens Long press to change from main view to telemetry screen Press until screen changes, about a second, an then release Power of the transmitter by pressing the power button till the screen goes blank, about 3 seconds. Remove power from any receivers that are bound to it. Clear any warnings by following the instructions on the screen. Power on the Tx by pressing and releasing the power button. The screws are being held in plastic which could could get damaged When tightening the screws just make them firm. Take care not to damage the module bay pins I tightened 3 all the way and tightened 4 till I liked the feel when moving the stick Tighten according to your personal preference Screw 4 affects the ratcheting (stepped) friction on the vertical axis Screw 3 affects the smooth friction on the vertical axis Turn screws 3 and 4 clockwise, to the right. You may find that the throttle stick will move on its ownĬheck the amount of slack on the gimbal wires shown and adjust if necessary. Note there is now tension on the spring again, this is normal. Turn screw 2 clockwise, right, till it is all the way down. Turn screw 1 counterclockwise, left, till the spring tension is completely removed. Note where the screw threads are visible and the spring tension. Carefully separate the two halves of the case in a vertical motion till the pins in the module bay are clearīe careful not to damage the pins in the module bay. There is a wire connected to it and a circuit board under it If the Rx is connected to the ESC throttle please remove the propeller. This basic configuration is enough to get flying once a receiver is bound to the transmitter. The preloaded software, OpenTX, comes with mode 2 as the default setting and one model configured with four channel outputs. For mode 2 the gimbal on the left needs it’s vertical axis (throttle) spring disabled and friction added. The transmitter (Tx) comes with both sticks spring loaded to centre the sticks. This post and video covers what to do with the transmitter from the time it arrives till the first model is bound and ready to fly.
0 kommentar(er)
